Steep sites and upper-slope runoff
Identify the lowest basins, steep drive aisles, safe truck access point and whether sanding grit, leaves or gravel are packing the drain before rain.
Start with catch basin cleaningNorth Vancouver service area
Catch basin cleaning, storm drain service, hydro jetting, camera inspections and drainage repair support in North Vancouver and nearby Lower Mainland areas.
Lower Mainland rain can turn a neglected basin into a flooded parking lot, parkade ramp, loading bay or driveway fast. We clean basins, flush lines, inspect recurring backups and help identify repair points.
Before you call
For steep drive aisles, parkades or tree-heavy lots, note the downhill problem area, clearance or access limits, basin count and how quickly water is collecting.
Call (778) 312-3314Local drainage priorities
North Vancouver service calls often involve steep drive aisles, parkade ramps, tree-heavy commercial lots and access constraints that make routine cleaning easier than a storm-event response. Debris can move quickly from upper slopes to the lowest catch basins during sustained rain.
Send the access route, slope direction, parkade height limits if relevant, tree/debris load, basin count and where water moves during heavy rain.
Send North Vancouver site notesPriority local scopes
North Vancouver properties can shed debris quickly from upper slopes into low basins, so the best request notes distinguish routine cleaning from repeat-backup diagnosis.
Identify the lowest basins, steep drive aisles, safe truck access point and whether sanding grit, leaves or gravel are packing the drain before rain.
Start with catch basin cleaningFor plazas and strata roads, send basin count, debris type, gate or loading access, and whether pooling returns in the same low point.
Build a maintenance planFor parkade ramps, send the level, trench-drain count, elevator/electrical/storage risks and whether hydro jetting or camera inspection should be scoped with cleaning.
Use the parkade checklistServices by site condition
Start with the visible problem; follow the drainage path only as site conditions indicate.
When an accessible basin is full, vacuum removal targets sediment, leaves, gravel and sludge held in the sump.
View service →If a cleaned basin still holds water, flush accessible storm or perimeter lines to move reachable debris beyond the sump.
View service →For repeat backups or an unclear route, inspect a reachable pipe to document visible debris, roots, offsets, low spots or damage.
View service →When inspection documents a structural defect, locate the affected section before repair scope is planned.
View service →Parkade and strata drains
If water is collecting inside a parkade, at a steep ramp drain, or along a strata road, send the entrance, level, drain count, slope notes and repeat-backup history before the next rain window.
For strata and commercial buildings with ramp drains, trench drains, sump-adjacent low points or water moving toward elevator and storage areas.
View parkade drain cleaningFor repeat backups on steep sites, cleaning may need to be paired with line flushing or camera inspection to confirm the private storm-line route.
Read the decision guideNorth Vancouver drainage decisions
Use these notes to decide whether a site likely needs routine basin cleaning, outlet-line flushing or a closer inspection before the next heavy rain.
Yes. We support commercial, strata, retail and light industrial sites, including parking lots, parkade ramps, loading areas, building entrances and steep-access drive aisles where water collects quickly.
If a basin is clean but water still drains slowly, backs up after rain, or repeats in the same area, add hydro jetting and consider camera inspection or locate support before planning repairs.
Send the site address or nearest cross street, approximate basin or trench-drain count, where water is pooling, access notes for slopes or parkades, and whether this is routine maintenance or active flooding.